Door monitor

This one is an older project, going back to one of the first ESP8266 boards I got my hands on. Perhaps your house is like mine, fitted with an alarm system that checks windows, doors, and motion sensors to detect break-ins or other unwanted visitors. It was here when we moved in, and I don't think was even supported by the original company anymore, not that we even had the intention of paying for a security subscription in the first place.

For all the bells and whistles the original system might offer, at the end of the day the sensors that actually run the system are made up of a bunch of switches that will either open or close when an event is detected. For example, magnetic switches on doors and windows will open when they are open, and motion detectors will either open or close for a few seconds whenever someone walks by. Conveniently, all the wires for these switches connect to the same point, which is the box that contains the original alarm controller.

The first step was to remove the old controller board. It's still around, along with the old keypads that we removed and patched the drywall behind.